xe pool-disable-external-auth not work you can try xe host-management-reconfigur e to configure the mgmt-interface otherwise (if no VM’s use the local-vm -storage) the fastest way is to use a cd and reinstall the server (no upgrade, this keeps the bad settings) and rejoin the pool.
10/19/2010 · xe pool-disable-external-auth . That command times out. Adding the switch -s 192.168.123.230 tells me the connection has been reset by peer. This is after I had manually assigned the IP address via CLI using traditional linux methods (ifconfig eth0) and.
11/14/2011 · xe pool-disable-external-auth This took a while to run and reported errors because it couldn’t disable external authentication on other systems it knew to be in the same cluster, but it actually did disable it on the host in question.
pool-disable-external-auth p ol -d is ab e ct r gh n pool-disable-redo-log pool-dump-database pool-eject pool-emergency-reset-master pool-emergency-transition-to-master pool-enable-external-auth … xe -toolstack-restart Restarts the XAPI-tools df -h Shows the amount of free disk space, 2/11/2011 · If you cannot remove it from the GUI, try this command: xe pool-disable-external-auth . Then re-join the domain. I had a slightly similar problem a while back in that I lost connection to the AD server, but I was also experiencing problems with the networking as well. http:// community.spiceworks.com /topic/114786.
5/28/2020 · pool-disable-external-auth reqd params : optional params : uuid, config: description : Disables external authentication in all the hosts in a pool, xe pool-disable-external-authXenCenter and CLI defines users in different names. XenCenter uses user, and CLI uses subject. So, adding users from XenCenter is pretty straight-forward, but, from CLI you should type this: CLI> xe subject-add subject-name= To remove a user, you should follow a.
Some xe commands, for example xe vm-migrate or xe pool-enable-external-auth, take secrets like passwords as parameters. These can end up in the shell history and during execution of the command are visible in the process table.
Run the pool-disable-external-auth command, specifying the pool uuid if required. Leaving the domain will not cause the host objects to be removed from the AD database. See this knowledge base article for more information about this and how to remove the disabled host entries.
